Searched the forums and most people state the exhaust tube size is 2.5" for OEM. I'm specifically looking at the part circled in red. I believe this is 2.5" 2 bolt flange, can anyone confirm?
Trying to get a local muffler shop to make me a custom bolt up exhaust for my FX45. Here are my thoughts so far:
2 Stainless steel 90 degree mandrel bent tubes (for the tips)
2 Stainless steel 2.5" inlet, 4" outlet tips
1 Stainless steel 2.5" 2 bolt flange
1 Stainless steel ball flanged pipe for the 2 bolt flange
1 Stainless steel donut gasket
1 Stainless steel 180 degree mandrel bent tube (angle is less but will modify it from there to get the angle I need)
1 Stainless steel muffler transverse style (Camaro) 2.5" in 2.5" dual out (most likely Borla).
2 exhaust hangers
Any comments/suggestions are welcome. I'm guessing the total cost would be about the same of the HKS rear bolt on muffler, but HKS sound doesn't do it for me.
Trying to get a local muffler shop to make me a custom bolt up exhaust for my FX45. Here are my thoughts so far:
2 Stainless steel 90 degree mandrel bent tubes (for the tips)
2 Stainless steel 2.5" inlet, 4" outlet tips
1 Stainless steel 2.5" 2 bolt flange
1 Stainless steel ball flanged pipe for the 2 bolt flange
1 Stainless steel donut gasket
1 Stainless steel 180 degree mandrel bent tube (angle is less but will modify it from there to get the angle I need)
1 Stainless steel muffler transverse style (Camaro) 2.5" in 2.5" dual out (most likely Borla).
2 exhaust hangers
Any comments/suggestions are welcome. I'm guessing the total cost would be about the same of the HKS rear bolt on muffler, but HKS sound doesn't do it for me.