Infiniti FX Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
15 Posts
Discussion Starter #1
I was replacing a worn out wheel stud on the back passenger side of my FX35 (which means I had to remove the brake caliper and the rotor) and after replacing the stud and putting everything back on, the car will not start. I get flashing Slip, VDCoff and ABS lights before I try to turn the engine. The engine will not turn over at all. The whole system appears to be locked up. Has anyone experienced this? Anyone know of a fix?

Trying to avoid a tow truck trip to a mechanic...
 

·
Registered
Joined
·
2,163 Posts
Do a search for brakes and sensor. I recall something about needing to be really careful with abs sensors when in there. May have been in context of rotor swap, and needing to carefully hang sensor out of way.
 
1 - 2 of 2 Posts
Top