[shajan]

Hey 4tyson,

Do you have any info on what signal wires the installer used? The ones that go into the LOC. I looked at esemes' diagrams but it doesn't specify the harness or the wire codes for the balaned inputs into the amp. I opened up the trunk and there are two harnesses(one blue and one off-white) going into the amp and there is a white harness on the side. I'll post pictures later.

I'm trying to tap inputs for my after-market amp.

Following pic shows the three harnesses I see. Anyone know what is what??

 

[4tyson]

Hello,

I am not sure exactly. Check out the link below as it has the diagrams that I passed on to the installers. I know it was a bit of a mess finding / sorting out the wires. They actually tapped into the wires behind the deck but it would be ok to tap them at the amp as well.

http://www.infinitifx.org/phpBB2/viewtopic.php?t=511

Let me know if that helps.

Thanks

 

[shajan]

Thanks 4tyson.

Yeah, I got those diagrams already. What I'm looking for is all the harness connections(input & output).

The diagrams show most of the amp outputs in detail but no details on the inputs to the amp.

 

[4tyson]

try

http://members.rogers.com/muran0/Connector%20Info.htm