Infiniti FX Forum banner
1 - 5 of 5 Posts

·
Premium Member
Joined
·
5,581 Posts
Discussion Starter · #1 ·
Question for those who use the Porter Cable.....

What speed to you zanio at?

I was using 3.5 but I think that is a bit too slow.
 

·
Registered
Joined
·
527 Posts
Sweet....which one of the PC orbitals are you using? I was thinking that it might be beneficial to get one. Has it reduced your time much? Also, which pads are you using to apply?
 

·
Registered
Joined
·
142 Posts
Sweet Fx said:
Question for those who use the Porter Cable.....

What speed to you zanio at?

I was using 3.5 but I think that is a bit too slow.

3.5 with Zaino is fine:)
Remember, you are not polishing with Zaino, just wanting to apply a very light protective coating.

Hope this helps...
 

·
Premium Member
Joined
·
5,581 Posts
Discussion Starter · #4 ·
h00kemh0rns said:
Sweet....which one of the PC orbitals are you using? I was thinking that it might be beneficial to get one. Has it reduced your time much? Also, which pads are you using to apply?
PC 7424

Only did the compunds so far on the FX, but did the z in about 15 mins to put on.

Doing the FX tomorrow and will time it.

I got pads for Waynestowels, they are real nice and were the best price that I could find.
 

·
Premium Member
Joined
·
5,581 Posts
Discussion Starter · #5 ·
Well, I was going to clean the FX and realized I had a ton of housework to do. :(

I will do it sometime this week after work :D
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top