Infiniti FX Forum banner
1 - 6 of 6 Posts

·
Registered
Joined
·
882 Posts
Discussion Starter · #1 ·
I wanted you opinions as to if I should install the pulley I just baought because there are two dings in them more like gashes and I wanted to know if you thought it was wise to install the pulley. I just concerned about the rotational balance of the pulley. Am I just being paranoid? I think it'll be ok but wanted to be sure since this pulley is going to be attached to my crank shaft.





 

·
Registered
Joined
·
3,948 Posts
I think it'll be just fine.
 

·
Premium Member
Joined
·
2,609 Posts
If the dings are just small deformations of the metal then you'll be fine. If peices of metal were removed (or significantly relocated) then that could change the overall ballance. Based on your pics, I think it will be OK.
 

·
Registered
Joined
·
882 Posts
Discussion Starter · #5 ·
thanks guys...yeah there doesn't seem to be chunks missing just that the metal was compressed in some areas. I know that aluminum is not a very hard metal.
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top