Infiniti FX Forum banner

1 - 9 of 9 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
Tried adding a bass to my FX and now I'm stuck. Not sure what to do. Not sure how to make the Low Level lines (Black and white from the subwoofer) into RCA cables to connect them to the amplifier. Any help would be greatly appreciated
 

·
Registered
Joined
·
50 Posts
Tried adding a bass to my FX and now I'm stuck. Not sure what to do. Not sure how to make the Low Level lines (Black and white from the subwoofer) into RCA cables to connect them to the amplifier. Any help would be greatly appreciated

I think you need an LOC: https://www.crutchfield.com/S-V7r6X6dG2mI/learn/what-are-line-output-converters.html
I've used the stinger brand with no issues: https://www.ebay.com/itm/Stinger-SGN121-Pro-Series-Fixed-Line-Output-Converter-Speaker-Power-Wire-RCA-/260726076189?_trksid=p2385738.m4383.l4275.c10
 

·
Registered
Joined
·
5 Posts
Discussion Starter #3
I actually bought a line output converter but I'm not what to do from there since they're only two lines for the sub (white and black) but four lines for the Line output converter
 

·
Registered
Joined
·
50 Posts
just one sub right? It'll be a mono signal from amp to sub. So I think you will likely need to run the 4 wires in a parallel connection. show pics of your sub, the amp and wiring.


try this video tutorial see if it will help: https://youtu.be/woAfVpf3Krw


good luck.
 

·
Registered
Joined
·
50 Posts
The amp has power and has the remote turn on, no issues there. Just need to work on wiring the actually cars radio to the RCA cables and the line output converter.




Im connecting the positives on the Line Output Converter with the white wire and the negative, to the black cables that go into the Subwoofer.



Your pics are not showing up. Let's try this instead. Is your Amp, LOC & Sub wired like this shown below?



from this thread:
https://forums.nicoclub.com/diy-subwoofer-and-amplifier-installation-t605735.html


Again i'm only referring to the LOC, Sub & Amp though the diagram shows more. Notice their LOC is grounded. Is yours?
 

·
Registered
Joined
·
14 Posts
I don't know how you started or what type your using but a quick run down of a 2channel loc, is you connect to positive and negative terminals from a left speaker, and then a right speaker. connect to power, ground, and a remote, and last the rca will go to the amp for your sub.
 
1 - 9 of 9 Posts
Top