[FX4U2C]

Hi Guy's,
Changed lots of bulbs before..but never DS2's. Is there a step by step anywhere in the forum ? Or some1 who has done could give some tips please ?
ie. Does Airbox need come out ? Do you dis-conn Batt b4 starting ?

Thx

 

[gtxjoe]

PREPARATION BEFORE ADJUSTING
For details, refer to the regulations in your own country.
Before performing aiming adjustment, check the following.
1. Keep all tires inflated to correct pressures.
2. Place vehicle on flat surface.
3. Set that there is no-load in vehicle other than the driver (or equivalent weight placed in driver's position).
Coolant, engine oil filled up to correct level and full fuel tank.
LOW BEAM AND HIGH BEAM
1. Turn headlamp low beam on.
2. Use adjusting screws to perform aiming adjustment.

If the vehicle front body has been repaired and/or the headlamp assembly has been replaced, check aiming.
Use the aiming chart shown in the figure.

Basic illumination area for adjustment should be within the range shown on the aiming chart.
Adjust headlamp accordingly.

 

[FX4U2C]

Many thanks !!!!,
Question: It does not mention what position the inside control should be set at ?????

 

[esemes]

Many thanks !!!!,
Question: It does not mention what position the inside control should be set at ?????

be sure to:

• set the dial all the way UP, or "0" (i think) - giving the lights their highest setting[/*:m:8yorx9yl]
• be sure to wear some rubber gloves (tight fit playtex works well) to keep your hands off the bulbs, AND to add a bit of insulation[/*:m:8yorx9yl]
• UNPLUG the battery and let the car sit for at least 5 minutes to fully discharge the ignitors, etc... theres a standing charge left in these lights..[/*:m:8yorx9yl]
• keep the insulation poles facing the same way (down i think) on each side too[/*:m:8yorx9yl]