Infiniti FX Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
I changed a bearing on my 2010 fx35 and didn't remove the abs sensor and I believe I put the bearing in upside down because I'm getting awd abs trac control and vdc lights on the dash. Do I need a new sensor? Will the bearing be ok if I just flip it or will I need a new one?
 

·
Registered
Joined
·
4 Posts
I changed a bearing on my 2010 fx35 and didn't remove the abs sensor and I believe I put the bearing in upside down because I'm getting awd abs trac control and vdc lights on the dash. Do I need a new sensor? Will the bearing be ok if I just flip it or will I need a new one?
bearing should be fine. on the assembly you should see small slits: this is where the sensor goes. if you install it the wrong way the bearing wont go it because the sensor is in the way. when removing the bearing more often then not you damage the sensor anyway. best to do both at the same time. with those lights on it is definitely the sensor. best of luck!
 
1 - 2 of 2 Posts
Top